Allied Telesis AT-S63 - Manual (Page 39)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 39
Class-map Mode (config-cmap)#  Create classifiers and flow groups
for Quality of Service policies
Line Console mode (config-line)#  Set the console timer
 Activate and deactivate the
RADIUS or TACACS+ client for
manager and operator accounts
 Set the baud rate of the terminal
port
Multiple Spanning
Tree Mode (config-mst)#  Create multiple spanning tree
instances
 Specify a region’s name and
revision level.
Policy Map mode (config-pmap)#  Map flow groups to traffic classes
for Quality of Service policies
Port Interface Mode (config-if)#  Configure port settings
 Disable and enable ports
 Configure port mirroring
 Configure 802.1x port-based
network access control
 Create static port trunks
 Add and remove ports from VANs
 Create Quality of Service policies
Router mode (config-router)#  Add RIP to routing interfaces.
 Configure virtual routes for VRRP.
Static Port Trunk Interface
mode (config-if)#  Set the load distribution method
for static port trunks.
VLAN Configuration mode (config-vlan)#  Create VLANs
VLAN Interface Mode (config-if)#  Create a routing interface
 Designate the local interface
Class mode (config-pmap-c)#  Configure traffic classes for
Quality of Service policies
Table 1. AlliedWare Plus Modes
Mode Prompt Function