Allied Telesis AT-S63 - Manual (Page 794)

Chapter 41: MAC Address-based Port Security Commands
794 Section VIII: Port Security
SET SWITCH PORT INTRUSIONACTION
Syntax
set switch port= port intrusionaction=discard|trap|disable
Parameters
port Specifies the port where you want to change the
intrusion action. You can specify more than one port
at a time. For instructions on how to enter port
numbers, refer to “Port Numbers in Commands” on
page 48.
intrusionaction Specifies the action the port takes when it receives an
invalid frame. The options are:
discard The switch discards invalid frames on the
port. This is the default.
trap The switch discards invalid frames on the
port and sends an SNMP trap.
disable The switch discards invalid frames on the
port, sends an SNMP trap, and disables
the port.
Description
This command, which applies only to ports operating in the Limited
security mode, defines the response of the switch when a port receives an
invalid frame.
Example
The following command sets the intrusion action to trap on ports 12 and
21:
set switch port=12,21 intrusionaction=trap
AlliedWare Plus
Command
Syntax
To set a port to discard invalid packets:
switchport port-security violation protect
To set a port to discard invalid packets and to send SNMP traps:
switchport port-security violation restrict
Command
Available
AlliedWare Plus