Allied Telesis AT-S63 - Manual (Page 75)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 75
RESTART SWITCH
Syntax 1
restart switch
Syntax 2
restart switch module= value |all
Syntax 3
restart switch config=none
Syntax 4
restart switch config= filename .cfg
Parameters
config Specifies one of the following:
none Restores the default settings on a stand-
alone switch or a stack.
filename.cfg Specifies the filename of a new active
configuration file for a stand-alone switch or
a stack. The file must already exist in the file
system of a switch. If the filename contains
spaces, enclose it in double quotes.
module Specifies the stack ID number of a switch to reset in a
stack. To reset all of the switches, use the ALL option. The
ALL option is equivalent to the RESTART SWITCH
command in Syntax 1.
Syntax 1 Description
You use this command to reset all of the switches in a stack. The devices
initialize their management software and perform the discovery process.
Afterwards, the master switch uses its configuration file to configure the
parameter settings. The entire process may take several minutes.
Caution
A stack does not forward network traffic during the reset process.
Some network traffic may be lost.
To reset a stand-alone switch, refer to “RESTART REBOOT” on page 73.
Command
Available
AlliedWare Plus