Allied Telesis AT-S63 - Manual (Page 781)

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 781
ENABLE VRRP
Syntax
enable vrrp[= vrid |all]
Parameters
vrrp Specifies the ID of the virtual router. The options are:
vrid Specifies the ID of a single virtual router,
a number between 1 and 255.
all Specifies that all the virtual routers in
which the switch participates be enabled.
Description
This command enables VRRP on the switch, or enables the switch’s
participation in a specific virtual router. VRRP is disabled on the switch by
default, and virtual routers are enabled by default when you create them.
You must enable both VRRP and the virtual router for the virtual router to
operate.
Example
This example enables the switch to participate in virtual router 42:
enable vrrp=42
AlliedWare Plus
Command
Syntax
router vrrp vrid
enable
Modes
For the ROUTER VRRP command:
Configure mode
For the DISABLE command:
Router mode
Description
These AlliedWare Plus commands are used to enable individual virtual
routers. To enable VRRP on the switch, use the standard ENABLE VRRP
Command
Available
AlliedWare Plus