Allied Telesis AT-S63 - Manual (Page 309)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 309
For example, selecting LOCAL2 as the facility level assigns the numerical
code of 18 to all events sent to the syslog server by the switch.
The SYSLOGFORMAT parameter defines the content of the events.
Examples
The following command creates output definition number 10, sends the
messages to a syslog server in normal format with a facility level setting of
LOCAL6:
create log output=10 destination=syslog server=149.65.10.99
facility=local6 syslog format=normal
The following command creates output definition number 18 and sends all
of the messages to the syslog server. Because the FORMAT option is
omitted from the command, the messages are sent in extended format,
which is the default:
create log output=18 destination=syslog server=149.65.10.101
AlliedWare Plus
Command
Syntax
log host ipaddress output-id
Mode
Configure mode
Description
This AlliedWare Plus command is used to create syslog output definitions.
To create a definition, you specify the IP address of a syslog server and a
Table 8. Numerical Code and Facility Level Mappings
Numerical
Code
Facility Level Setting
17 LOCAL1
18 LOCAL2
19 LOCAL3
20 LOCAL4
21 LOCAL5
22 LOCAL6
23 LOCAL7