Allied Telesis AT-S63 - Manual (Page 661)

AT-S63 Management Software Command Line User’s Guide
Section VI: Virtual LANs 661
The information displayed by the command is described here:
 VLAN name - The name of the VLAN. The name is Client_VLAN
followed by the port number.
 VLAN ID - The ID number assigned to the VLAN.
 VLAN Type - The type of VLAN. This will be Port Based for the VLANs
of a multiple VLAN mode.
 Protected Ports - The status of protected ports. Since the VLANs of a
multiple VLAN mode are not protected ports VLANs, this will be No.
 Untagged port(s) - The untagged port of the VLAN.
 Tagged port(s) - The tagged port that is functioning as the uplink port
for the VLANs.
For an example of the information displayed by this command for a
protected ports VLAN, see Figure 78 on page 691. For an example of a
MAC address-based VLAN, see Figure 79 on page 701.
Examples
The following command displays all the VLANs on the switch:
show vlan
The following command displays information on just the Sales VLAN:
show vlan=sales
The following command displays information for the VLAN with the VID of
22:
show vlan=22
AlliedWare Plus
Command
Syntax
show vlan all
Modes
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command displays all of the VLANs on the switch.
You can use this command to display port-based and tagged VLANs, as
well as the VLANs in the multiple VLAN modes. This command cannot
display protected-ports VLANs or MAC address-based VLANs.