Allied Telesis AT-S63 - Manual (Page 126)

Chapter 6: Simple Network Time Protocol (SNTP) Commands
126 Section I: Basic Operations
SHOW SNTP
Syntax
show sntp
Parameters
None.
Description
This command displays the current settings for the client SNTP software
on the switch. An example of the display is shown in Figure 34.
Figure 34. SHOW SNTP Command
The information displayed by this command is described here:
 Status - The status of the SNTP client software on the switch. The
status can be either enabled or disabled. If enabled, the switch seeks
its date and time from an SNTP server. The default is disabled.
 SNTP - The IP address of the SNTP server.
 UTC Offset - The time difference in hours between UTC and local time.
The range is -12 to +12 hours. The default is 0 hours.
 Daylight Savings Time (DST) - The status of the daylight savings time
setting. The status can be enabled or disabled.
 Poll interval - The time interval between two successive queries to the
SNTP server. The range is 60 to 1200 seconds. The default is 600
seconds.
 Last Delta - The last adjustment applied to the system time. It is the
drift in the system clock between two successive queries to the SNTP
server.
Command
Available
AlliedWare Plus
SNTP Configuration:
Status ........................ Disabled
Server ........................ 0.0.0.0
UTC Offset .................... +0
Daylight Savings Time (DST) ... Enabled
Poll Interval ................. 600 seconds
Last Delta .................... +0 seconds