Allied Telesis AT-S63 - Manual (Page 474)

Chapter 25: Internet Group Management Protocol (IGMP) Snooping Commands
474 Section III: Snooping Protocols
SHOW IGMPSNOOPING
Syntax
show igmpsnooping
Parameters
None.
Description
This command displays the IGMP parameters. Figure 62 illustrates the
information.
Figure 62. SHOW IGMPSNOOPING Command
For an explanation of these parameters, refer to “SET IP IGMP” on
page 470 and “SHOW IP IGMP” on page 476.
Command
Available
AlliedWare Plus
IGMP Snooping Configuration:
IGMP Snooping Status ............... Enabled
Querier Admin ...................... Disabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum IGMP Multicast Groups ...... 64
Router Port(s) ..................... Auto Detect
Router List:
VLAN
Port/ Exp.
ID Trunk ID RouterIP Time
----------------------------------------------------
1
12 172.16.01.1 22
Host List:
Number of IGMP Multicast Groups: 4
VLAN Port/ IGMP Exp.
MulticastGroup ID TrunkID HostIP Ver Time
------------------------------------------------------------
01:00:5E:00:01:01 1 6/- 172.16.10.51 v2 21
01:00:5E:7F:FF:FA 1 5/- 149.35.200.75 v2 11
149.35.200.65 v2 65
01:00:5E:00:00:02 1 17/- 149.35.200.69 v2 34
01:00:5E:00:00:09 1 14/- 172.16.10.51 v2 32
VLAN Querier Interface Exp. Query Version 1
ID Status IP Address Time Version Source Port
-----------------------------------------------------------