Allied Telesis AT-S63 - Manual (Page 430)

Chapter 22: Group Link Control Commands
430 Section II: Advanced Operations
CREATE GLC
Syntax
create glc group [ downstream_port ] [ upstream_port ]
Parameters
group Specifies an ID number for a new group. The range is 1 to
8.
downstream_ Specifies a downstream port. You can specify more than
port
one port.
upstream_ Specifies an upstream port. You can specify more than
port one port.
Description
This command is used to create new groups. Here are the guidelines:
 You can create groups with or without the ports. If you create a group
without ports, you can add them later with the ADD GCL command, as
explained in “ADD GLC” on page 428.
 This command does not activate group link control. That is performed
separately with the standard ENABLE GLC command, as explained in
“ENABLE GLC” on page 437.
 A new group is immediately functional if group link control is activated
on the switch or stack. If there is no link on the upstream port, the
downstream port will not forward traffic.
Examples
This command creates a new group with an ID number 1. Port 15 is a
downstream port and port 2 is an upstream port.
create glc 1 15 2
This command creates a group with an ID number 2. No ports are
specified. They will be added later with the ADD GLC command.
create glc 2
AlliedWare Plus
Command
Syntax
group link control group
Command
Available
AlliedWare Plus