Enable stp, Alliedware plus command – Allied Telesis AT-S63 User Manual

Page 576

Text mode
Original mode

Chapter 31: Spanning Tree Protocol (STP) Commands

576

Section V: Spanning Tree Protocols

ENABLE STP

Syntax

enable stp

Parameters

None.

Description

This command enables the Spanning Tree Protocol. To view the current
status of STP, refer to “SHOW STP” on page 586. The default setting for
STP is disabled.

Note

You cannot enable STP until after you have activated it with
“ACTIVATE STP” on page 574.

Example

The following command enables STP:

enable stp

AlliedWare Plus

Command

Syntax

spanning-tree stp enable

Mode

Configure mode

Description

This AlliedWare Plus command is identical to the standard command.

Example

awplus> enable
awplus# configure terminal
awplus(config)# spanning-tree stp enable

Command

Available

AlliedWare Plus