Allied Telesis AT-S63 - Manual (Page 633)

AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols 633
The following command sets the internal port cost for Ports 2 and 5 to
Auto, which sets the port cost based on speed:
set mstp port=2-5 intportcost=auto
AlliedWare Plus
Command
Syntax
spanning-tree path-cost path-cost
spanning-tree priority priority
spanning-tree edgeport|portfast
spanning-tree link-type point-to-point|shared
Mode
Port Interface mode
Description
This AlliedWare Plus command has the following rules and restrictions:
 The PATH-COST parameter sets the external path cost of a port.
 The EDGEPORT and PORTFAST parameters are equivalent and are
used to specify whether or not a port is an edge port of an MSTI.
 You cannot use the AlliedWare Plus commands to set the internal port
cost or the migration check of a port. To set these parameters, use the
standard command or another management interface.
 When setting a port’s priority, you can use the SPANNING TREE
PRIORITY command in the Port Interface mode if the port has just one
MSTI or if it has multiple MSTIs and you want to assign all of them the
same priority value. However, if you want to assign different priority
values to a port that belongs to more than one MSTI, use the standard
command.
Examples
These commands assign port 2 a port cost of 15 and a port priority of 192
(increment 12):
awplus> enable
awplus# configure terminal
awplus(config)# interface 2
awplus(config-if)# spanning-tree path-cost 15
awplus(config-if)# spanning-tree priority 12
These commands designate port 22 as an edge port:
awplus> enable
awplus# configure terminal
awplus(config)# interface 22
awplus(config-if)# spanning-tree edgeport