Allied Telesis AT-S63 - Manual (Page 224)

Chapter 12: LACP Port Trunking Commands
224 Section I: Basic Operations
DELETE LACP PORT
Syntax
delete lacp aggregator= name port= port
Parameters
aggregator Specifies the name of the aggregator. The name is
case-sensitive.
port Specifies the port to delete from an aggregator. You
can delete more than one port at a time.
Description
This command removes a port from an aggregator. You must identify the
aggregator by its name. To display the names of the aggregators on the
switch, refer to “SHOW LACP” on page 233. To completely remove an
aggregator, see “DESTROY LACP AGGREGATOR” on page 226.
Caution
Disconnect the network cable from a port before removing it from an
aggregator. Removing a port without first disconnecting the cable
can result in loops in your network topology, which can result in
broadcast storms and poor network performance.
Note
You cannot delete the lowest numbered port from an aggregator,
also referred to as the base port. For example, if an aggregator
consists of ports 7 to 12, you cannot delete port 7. You must delete
and recreate an aggregator to remove the base port.
Example
The following command removes port 9 from the “lacp_server”
aggregator:
delete lacp aggregator=lacp_server port=9
AlliedWare Plus
Command
Syntax
no channel-group integer
Command
Available
AlliedWare Plus