Allied Telesis AT-S63 - Manual (Page 120)

Chapter 6: Simple Network Time Protocol (SNTP) Commands
120 Section I: Basic Operations
DELETE SNTPSERVER PEER|IPADDRESS
Syntax
delete sntpserver peer|ipaddress= ipaddress
Parameter
peer or Specifies the IP address of an SNTP server. The
ipaddress parameters are equivalent.
Description
This command deletes the IP address of the SNTP server from the SNTP
client software on the switch and returns the parameter to the default
value of 0.0.0.0. To view the IP address, refer to “SHOW SNTP” on
page 126.
Example
The following command deletes the SNTP server with the IP address
148.35.16.248:
delete sntpserver ipaddress=148.35.16.248
AlliedWare Plus
Command
Syntax
no ntp server ipaddress
Mode
Configure Terminal
Description
This command automatically deactivates the SNTP client when you
remove from the client the IP address of the SNTP server. The other
management interfaces have different commands for removing the IP
address of the server and for deactivating the client.
Example
This example removes the IP address of the SNTP server and deactivates
the client:
awplus> enable
awplus# configure terminal
awplus(config)# no ntp server 152.140.22.4
Command
Available
AlliedWare Plus