Allied Telesis AT-S63 - Manual (Page 200)

Chapter 10: MAC Address Table Commands
200 Section I: Basic Operations
SHOW SWITCH AGINGTIMER|AGEINGTIMER
Syntax
show switch agingtimer|ageingtimer
Parameters
None.
Description
This command displays the current setting for the aging timer. The switch
uses the aging timer to delete inactive dynamic MAC addresses from the
MAC address table. To set the aging timer, refer to “SET SWITCH
AGINGTIMER|AGEINGTIMER” on page 198.
Figure 38 illustrates the information displayed by this command.
Figure 38. SHOW SWITCH AGINGTIMER|AGEINGTIMER Command
Example
The following command displays the current setting for the MAC address
aging timer:
show switch agingtimer
AlliedWare Plus
Command
To view the aging timer with the AlliedWare Plus commands, refer to the
AlliedWare Plus command in “SHOW SWITCH FDB” on page 201.
Command
Available
AlliedWare Plus
Aging interval: 300 second(s)