Allied Telesis AT-S63 - Manual (Page 371)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 371
SHOW QOS CONFIG
Syntax
show qos config
Parameters
None.
Description
Displays the CoS priority queues and scheduling. Figure 57 is an example
of the information displayed by this command.
Figure 57. SHOW QOS CONFIG Command
The current mapping of CoS priorities to port egress queues is displayed
in the top section. As an example, at the default setting packets with a CoS
priority of 3 are stored in egress queue 3 of a port.
The bottom section of the display shows the scheduling method of the
switch ports. In strict priority, a port transmits all packets out of the higher
priority queues before transmitting any from the low priority queues. This is
the default. In weighted round robin, a port transmits a set number of
packets from each queue. The weights only show a value when a port is
Command
Available
AlliedWare Plus
QoS Configuration information:
Number of CoS Queues .......... 8
CoS 0 Priority Queue .......... Q1
CoS 1 Priority Queue .......... Q0
CoS 2 Priority Queue .......... Q2
CoS 3 Priority Queue .......... Q3
CoS 4 Priority Queue .......... Q4
CoS 5 Priority Queue .......... Q5
CoS 6 Priority Queue .......... Q6
CoS 7 Priority Queue .......... Q7
Scheduling Mode ............... Strict Priority
Queue 0 Weight ................ 0
Queue 1 Weight ................ 0
Queue 2 Weight ................ 0
Queue 3 Weight ................ 0
Queue 4 Weight ................ 0
Queue 5 Weight ................ 0
Queue 6 Weight ................ 0
Queue 7 Weight ................ 0