Allied Telesis AT-S63 - Manual (Page 390)

Chapter 21: Quality of Service (QoS) Commands
390 Section II: Advanced Operations
Policy 15 Commands:
create classifier=42 description=database
ipsadddr=149.44.44.44
create qos flowgroup=36 description=database
classifierlist=42
create qos trafficclass=21 description=database
maxbandwidth=50 flowgrouplist=36
create qos policy=15 description=database
trafficclasslist=21 ingressport=1
Policy 17 Commands:
create classifier=10 description=database
ipdadddr=149.44.44.44
create qos flowgroup=12 description=database
classifierlist=10
create qos trafficclass=17 description=database
maxbandwidth=50 flowgrouplist=12
create qos policy=17 description=database
trafficclasslist=17 ingressport=8
AlliedWare Plus
Command
Syntax
service- policy input id_number
Mode
Port Interface mode
Description
This AlliedWare Plus command is used to create Quality of Service
policies. To use the command, you first enter the Port Interface mode for
the ports to be assigned the policy. You then enter this command, using
the ID_NUMBER variable to identify the ID number of the traffic class for
the policy. The command automatically creates the policy, assigning it the
same ID number as the traffic class, and attaches the policy to the ports,
which are considered ingress ports of the policy.
If you examine the standard “CREATE QOS POLICY” on page 384, you’ll
see that policies actually have quite a few parameters. However, most of
them are not available to you when you create policies with this
AlliedWare Plus command. The only two parameters that you can set are
the ingress ports, which, as just explained, you identify with the Port