Allied Telesis AT-S63 - Manual (Page 397)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 397
set tos-priority enable|disable
set priority-tos enable|disable
Mode
To create a traffic class:
Configure mode
To map a flow group to a traffic class:
Policy Map mode
To configure the traffic class parameters:
Class mode
Description
These commands have the following restrictions:
 The flow group must already exist.
 You cannot use the AlliedWare Plus commands to modify existing
traffic classes. Instead, use “SET QOS TRAFFICCLASS” on page 414
or another management interface.
Example
This example creates a new traffic class with the ID number 11. The ID
number of the flow group for the traffic class is 274. The traffic class is
assigned a maximum bandwidth of 750 Mbps:
awplus> enable
awplus# configure terminal
awplus(config)#
policy-map 11
awplus(config-pmap)# class 274
awplus(config-pmap-c)# set bandwidth 750
This example creates a traffic class for a flow group that has the ID
number 302. The traffic class is assigned the ID number 12. The traffic
class sets the priority of the packets of the traffic flow to 7 and enables the
remark option so that the packets retain the new value when they exit the
switch:
awplus> enable
awplus# configure terminal
awplus(config)#
policy-map 12
awplus(config-pmap)# class 302
awplus(config-pmap-c)# set priority 7
awplus(config-pmap-c)# set remark-priority enable