Allied Telesis AT-S63 - Manual (Page 422)

Chapter 21: Quality of Service (QoS) Commands
422 Section II: Advanced Operations
set to No, which is the default, the packets retain their preexisting
802.1p priority level.
 Move Priority to ToS - If set to yes, replaces the value in the ToS
priority field with the value in the 802.1p priority field on IPv4 packets.
If set to No, which is the default, the packets retain their preexisting
ToS priority level.
 Send to Mirror Port - Copies the traffic that meets the criteria of the
classifiers to a destination mirror port. If set to yes, you must specify
the destination port of the port mirror with “SET SWITCH MIRROR” on
page 238.
 Traffic Class List - The traffic classes assigned to the policy.
 Redirect Port - The egress port to which the classified traffic from the
ingress port is reassigned.
 Ingress Port List - The ingress ports to which the policy is assigned.
 Egress Port - The egress port to which the policy is assigned.
 Active - The status of the policy. A policy that is assigned to one or
more ports is deemed active while a policy that is not assigned to any
ports is deemed inactive.
For further information about the parameters, refer to “CREATE QOS
POLICY” on page 384.
Examples
This command displays all of the policies:
show qos policy
This command displays policy 54:
show qos policy=54
AlliedWare Plus
Command
Syntax
show service-policy [ id_number ]
Mode
User Exec mode and Privileged Exec mode
Description
This AlliedWare Plus command is equivalent to the standard command.