Allied Telesis AT-S63 - Manual (Page 537)

AT-S63 Management Software Command Line User’s Guide
Section IV: SNMPv3 537
DESTROY SNMPv3 TARGETADDR
Syntax
destroy snmpv3 targetaddr= target
Parameter
targetaddr Specifies an SNMPv3 Target Address table entry.
Description
This command deletes an SNMPv3 Target Address Table entry. After you
delete an SNMPv3 Target Address Table entry, you cannot recover it.
Example
The following command deletes an SNMPv3 Address Table entry called
“snmpmanager.”
destroy snmpv3 targetaddr=snmpmanager
AlliedWare Plus
Command
Syntax
no snmp-server targetaddr target
Mode
Configure mode
Description
This AlliedWare Plus command is identical to the standard command.
Example
This example deletes an SNMPv3 Target Address Table entry called
“snmpv3host5”:
awplus> enable
awplus# configure terminal
awplus(config)# no snmp-server targetaddr snmpv3host5
Command
Available
AlliedWare Plus