Allied Telesis AT-S63 - Manual (Page 598)

Chapter 32: Rapid Spanning Tree Protocol (RSTP) Commands
598 Section V: Spanning Tree Protocols
 Forwarding delay
 Maximum age time
 Force version of STP or normal RSTP
This command can also return the RSTP parameters to their default
settings.
Note
You can use this command only if RSTP is the active spanning tree
protocol on the switch. See “ACTIVATE RSTP” on page 590.
Examples
The following command sets the bridge priority to 20480 (increment 5), the
hello time to 5 seconds, and the forwarding delay to 20 seconds:
set rstp priority=5 hellotime=5 forwarddelay=20
The following command uses the FORCEVERSION parameter to
configure the bridge to use the RSTP parameters but to transmit only STP
BPDU packets:
set rstp forceversion=stpcompatible
The following command returns all RSTP parameter settings to their
default values:
set rstp default
Equivalent Command
purge rstp
For information, see “PURGE RSTP” on page 595.
AlliedWare Plus
Command
Syntax
spanning-tree priority priority
spanning-tree hello-time hello-time
spanning-tree forward-time forward-time
spanning-tree max-age max-age
spanning-tree forceversion 1|2|3
Mode
Configure mode