Allied Telesis AT-S63 - Manual (Page 527)

AT-S63 Management Software Command Line User’s Guide
Section IV: SNMPv3 527
privacy This option provides an
authentication protocol and the
privacy protocol.
storagetype Specifies the storage type of this table entry. This is
an optional parameter. The options are:
volatile Does not allow you to save the table
entry to the configuration file on the
switch. This is the default.
nonvolatile Allows you to save the table entry to
the configuration file on the switch.
Description
This command creates an SNMPv3 Target Parameters Table entry.
Examples
In the following command, the Target Parameters Table entry is called
“snmpv3mgr13” and user name is “user444.” The security model is set to
the SNMPv3 protocol. In addition, the security level is set to privacy and
the storage type is nonvolatile.
create snmpv3 targetparams=snmpv3mgr13 username=user444
securitymodel=v3 messageprocessing=v3 securitylevel=privacy
storagetype=nonvolatile
In the following command, the Target Parameters Table entry is called
“snmpmanager” and the user name is “pat365.” The security model is set
to SNMPv3 protocol. In addition, the security level is set to authentication
and the storage type is nonvolatile.
create snmpv3 targetparams=snmpmanager username=pat365
securitymodel=v3 messageprocessing=v3
securitylevel=authentication storagetype=nonvolatile
AlliedWare Plus
Command
Syntax
snmp-server targetparams targetparams user username secure
noauth|auth|priv model v1|v2c|v3 message v1|v2c|v3
Mode
Configure mode
Description
This command differs from the standard command as follows: