Allied Telesis AT-S63 - Manual (Page 167)

AT-S63 Management Software Command Line User’s Guide
Section I: Basic Operations 167
awplus(config-if)# speed auto
This example sets the wiring configuration for port 28 to MDI:
awplus> enable
awplus# configure terminal
awplus(config)# interface 28
awplus(config-if)# polarity mdi
This example activates backpressure on port 15:
awplus> enable
awplus# configure terminal
awplus(config)# interface 15
awplus(config-if)# flowcontrol backpressure on
This example activates flow control on ports 11 and 18:
awplus> enable
awplus# configure terminal
awplus(config)# interface 11,18
awplus(config-if)# flowcontrol receive on
awplus(config-if)# flowcontrol send on
This example sets the threshold for flow control and backpressure on ports
15 and 20 to 7000 cells:
awplus> enable
awplus# configure terminal
awplus(config)# interface 15,20
awplus(config-if)# bplimit 7000
This example performs a soft reset on ports 18 to 21:
awplus> enable
awplus# configure terminal
awplus(config)# interface 18-21
awplus(config-if)# softreset
To set the wiring configuration on a port, you must disable Auto-
Negotiation and set the speed and duplex mode manually.
This example assigns the name “printer22” to port 15:
awplus> enable
awplus# configure terminal
awplus(config)# interface 15
awplus(config-if)# description printer22
The description of a port cannot contain spaces.
This example disables port 3:
awplus> enable