Allied Telesis AT-S63 - Manual (Page 713)

AT-S63 Management Software Command Line User’s Guide
Section VII: Internet Protocol Routing 713
This command adds RIP to the VLAN12-2 interface. It configures the
protocol to send version 2 packets and accept packets of either version.
The password for authentication is “net25aqy”:
add ip rip interface=vlan12-2 send=rip2 receive=both
authentication=pass password=net25aqy
AlliedWare Plus
Command
Syntax
To add RIP to a routing interface:
network interface
To set the version of RIP packets the routing protocol will transmit:
send rip1|rip2 interface
To set the version of RIP packets the routing protocol will accept:
recv rip1|rip2|both interface
To enable or disable password protection for RIP version 2:
authentication pass|none interface
To set the password used to authenticate RIP version 2 packets:
password password interface
To activate split horizon with poison reverse:
poison-reverse interface
To activate split horizon:
no poison-reverse interface
To enable autosummary of routes:
auto-summary interface
To disable autosummary of routes:
no auto-summary interface
Mode
Router mode
Description
These AlliedWare Plus commands are equivalent to the standard
command.