Allied Telesis AT-S63 - Manual (Page 326)

Chapter 17: Event Log and Syslog Client Commands
326 Section II: Advanced Operations
SHOW LOG
Syntax
show log[=permanent|temporary] [full] [module= module ]
[reverse] [severity= severity ]
Parameters
log Specifies which of the two event logs you want to
view. The options are:
permanent Displays the events stored in
permanent memory.
temporary Displays the events stored in
temporary memory. This is the
default.
full Specifies the amount of information displayed by the
log. Without this option, the log displays the time,
module, severity, and description for each entry. With
it, the log also displays the filename, line number, and
event ID.
module Specifies the AT-S63 module whose events you want
displayed. For a list of modules, refer to Table 9 on
page 327.
reverse Specifies the order of the events in the log. Without
this option, the events are displayed oldest to newest.
With this option, the events are displayed newest to
oldest.
severity Specifies the severity of events to be displayed. The
options are:
all Displays events of all severity levels.
severity Displays events of a particular severity.
Choices are I for Informational, E for Error,
W for Warning, and D for Debug. You can
select more than one severity at a time (for
example, E,W). For a definition of the
severity levels, see Table 10, “Event Log
Severity Levels” on page 329. The
defaults are I, E, and W.
Command
Available
AlliedWare Plus