Allied Telesis AT-S63 - Manual (Page 736)

Chapter 38: Internet Protocol Version 4 Packet Routing Commands
736 Section VII: Internet Protocol Routing
The interface must be configured for RIP version 2 in
order for you to specify a password. Passwords are
not supported in RIP version 1.
Passwords are sent in plaintext. The AT-S63
Management Software does not support encrypted
passwords.
poisonreverse Specifies the status for split horizon and split horizon
with poison reverse. The options are:
yes, on, true Split horizon poison reverse is
enabled. These values are
equivalent.
no, off, false Split horizon poison reverse is
disabled, and split horizon is
executed. This is the default setting.
These values are equivalent.
autosummary Specifies the status for autosummarization of routes.
The options are:
yes, on, true Autosummarization of routes on the
RIP interface is enabled. These
values are equivalent.
no, off, false Autosummarization of routes on the
RIP interface is disabled. This is the
default setting. These values are
equivalent.
Description
This command modifies the RIP settings of an interface. To initially add
RIP to an interface, refer to “ADD IP RIP” on page 711. To view the
interfaces on the switch, refer to “SHOW IP INTERFACE” on page 745.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Examples
This command changes RIP on the VLAN4-3 interface to send version 2
packets, accept either version 1 or 2, and use the password “wa24pt” for
authentication:
set ip rip interface=vlan4-3 send=rip2 receive=both
authentication=pass password=wa24pt