Allied Telesis AT-S63 - Manual (Page 299)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 299
UPLOAD METHOD=XMODEM
Syntax
upload method=xmodem
srcfile|file=switchcfg|[cflash:]
filename |appblock
Parameters
method Specifies an Xmodem upload.
srcfile or file Specifies the file to be uploaded. Options are:
switchcfg Uploads the switch’s active boot
configuration file.
filename Specifies the name of a file to upload
from the switch’s file system or compact
flash card. If the file is stored on a
compact flash card, precede the name
with “cflash:”.
appblock Uploads the switch’s active AT-S63
image file.
Description
An XMODEM upload uses the Xmodem utility to upload a file from the
switch’s file system to a terminal or computer with a terminal emulator
program connected to the serial terminal port on the switch. You can use
the command to upload a switch’s active boot configuration file or any
other file from the file system, such as an SSL certificate enrollment
request or a public encryption key. You can also use this command to
upload a file on a compact flash memory card to your workstation. The
command also allows you to upload the switch’s active AT-S63 software
image from the application block to a your terminal or workstation, though
it is unlikely you would ever have need for that function.
When performing an Xmodem upload, note the following:
 An Xmodem upload must be performed from a local management
session.
 Xmodem can only upload a file from the switch where you started the
local management session. Xmodem cannot upload a file from a
switch accessed through enhanced stacking.