Allied Telesis AT-S63 - Manual (Page 492)

Chapter 27: Multicast Listener Discovery (MLD) Snooping Commands
492 Section III: Snooping Protocols
SHOW MLDSNOOPING
Syntax
show mldsnooping
Parameters
None.
Description
This command displays the following MLD parameters:
 MLD snooping status
 Multicast host topology
 Host/router timeout interval
 Maximum multicast groups
 Host and router lists
To set the MLD parameters, refer to “SET IPV6 MLDSNOOPING” on
page 488.
This command displays the information in Figure 67.
Figure 67. SHOW MLDSNOOPING Command
Command
Available
AlliedWare Plus
MLD Snooping Configuration:
MLD Snooping Status ................ Enabled
Host Topology ...................... Single-Host/Port (Edge)
Host/Router Timeout Interval ....... 260 seconds
Maximum MLD Multicast Groups ....... 64
Router Port(s) ..................... Auto Detect
Host List:
Number of MLD Multicast Groups: 1
VLAN Port/ Exp.
MulticastGroup ID TrunkID HostIP Time
-----------------------------------------------------------------------------------------
33:33:00:00:00:ab 1 6 fe80:0000:0000:0000:0208:74ff:feff:bf08 21
Router List:
VLAN Port/ RouterIP Exp.
Trunk ID Time
-----------------------------------------------------------------------------------------
1 14 fe80:0000:0000:0000:0200:cdff:fe12:bf08