Allied Telesis AT-S63 - Manual (Page 413)

AT-S63 Management Software Command Line User’s Guide
Section II: Advanced Operations 413
SET QOS PORT
Syntax
set qos port= value type=ingress|egress
policy= value |none
Parameter
port Specifies the port to be added to or removed from a policy.
A policy can have more than one ingress port, but only one
egress port. For instructions on how to enter port numbers,
refer to “Port Numbers in Commands” on page 48.
type Specifies whether the port is an ingress or egress port for
the policy. The default is ingress.
policy Specifies the policy to the assigned to the port. You can
specify only one policy. The NONE option removes the port
from its current policy assignment.
Description
This command adds and removes ports from policies.
A port can be an ingress or egress port of only one policy at a time.
However, a port can be an ingress port and an egress port of different
policies, simultaneously. If a port is already a port of a policy, this
command automatically removes it from its current policy assignment
before adding it to another policy.
Examples
This command assigns ports 5 through 8 as ingress ports in QoS policy
12:
set qos port=5-8 type=ingress policy=12
This command removes egress port 5 from its current policy assignment
without assigning it to another policy:
set qos port=5 type=egress policy=none