Allied Telesis AT-S63 - Manual (Page 232)

Chapter 12: LACP Port Trunking Commands
232 Section I: Basic Operations
SET LACP STATE
Syntax
set lacp state=enable|disable
Parameters
state Specifies the state of LACP on the switch. The options are:
enable Enables LACP.
disable Disables LACP. This is the default.
Description
This command is used to enable or disable LACP on the switch.
Caution
If there are aggregators defined on the switch, do not disable LACP
until you have disconnected all the cables from the aggregate trunk
ports. Otherwise, a network loop might occur, resulting in a
broadcast storm and poor network performance.
Example
The following command activates LACP on the system:
set lacp state=enable
Equivalent Commands
disable lacp
For information, see “DISABLE LACP” on page 227.
enable lacp
For information, see “ENABLE LACP” on page 228.
AlliedWare Plus
Command
The AlliedWare Plus interface does not have a separate command to
enable or disable LACP on the switch. LACP is automatically enabled
when you create the first aggregator and disabled when you delete the last
aggregator. For instructions, refer to the AlliedWare Plus commands in
“ADD LACP PORT” on page 220 and “DELETE LACP PORT” on
page 224.
Command
Available
AlliedWare Plus