Allied Telesis AT-S63 - Manual (Page 772)

Chapter 40: Virtual Router Redundancy Protocol (VRRP) Commands
772 Section VII: Internet Protocol Routing
AlliedWare Plus
Command
Syntax
To assign an ID to a new virtual router:
router vrrp vrid
To assign the interface and a secondary IP address:
virtual-ip ipaddress interface
To assign the interval in seconds between advertisement packets:
advertisement-interval value
To set authentication to plaintext:
password password
To set authentication to none:
no authentication
To enable or disable port monitoring:
port-monitor true|false
To specify whether or not ports should reset when a virtual router
transitions from backup to master status:
port-reset true|false
To specify whether a higher priority switch preempts a lower priority switch
acting as the master:
preempt-mode true|false
To set the priority:
priority value
To set the step value:
step-value value |proportional
To set the delay value:
delay value
Modes
For the ROUTER VRRP command:
Configure mode