Allied Telesis AT-S63 - Manual (Page 603)

AT-S63 Management Software Command Line User’s Guide
Section V: Spanning Tree Protocols 603
Note
The EDGEPORT and PORTFAST parameters are equivalent.
Mode
Port Interface mode
Description
These AlliedWare Plus commands are identical to the standard command.
Example
The following commands assign port 2 a port cost of 15 and a port priority
of 192 (increment 12):
awplus> enable
awplus# configure terminal
awplus(config)# interface 2
awplus(config-if)# spanning-tree path-cost 15
awplus(config-if)# spanning-tree priority 12
The following commands designate port 22 as an edge port:
awplus> enable
awplus# configure terminal
awplus(config)# interface 22
awplus(config-if)# spanning-tree edgeport
The following commands designate ports 17 and 23 as not edge ports:
awplus> enable
awplus# configure terminal
awplus(config)# interface 17,23
awplus(config-if)# no spanning-tree edgeport
This example designates ports 11 to 23 as point-to-point ports:
awplus> enable
awplus# configure terminal
awplus(config)# interface 11-23
awplus(config-if)# spanning-tree link-type point-to-point
This example designates ports 26 and 27 as not point-to-point ports:
awplus> enable
awplus# configure terminal
awplus(config)# interface 26,27
awplus(config-if)# spanning-tree link-type shared