Allied Telesis AT-S63 - Manual (Page 722)

Chapter 38: Internet Protocol Version 4 Packet Routing Commands
722 Section VII: Internet Protocol Routing
DELETE IP RIP
Syntax
delete ip rip interface= interface
Parameters
interface Specifies the name of the interface where RIP is to be
removed. An interface name consists of “VLAN”
followed by the name or ID (VID) of the VLAN and the
interface number (e.g., vlan-Sales-0 or vlan4-0).
Description
This command removes RIP from interfaces, which stops the interfaces
from routing packets with RIP. However, interfaces, even without RIP, can
route packets to other interfaces on the same switch and to remote
networks and subnets using static routes.
To view the names of the interfaces using RIP, refer to “SHOW IP RIP
COUNTER” on page 747.
This command is not available on the AT-9408LC/SP, AT-9424T/GB, and
AT-9424T/SP switches.
Example
This command removes RIP from the VLAN8-0 interface:
delete ip rip interface=vlan8-0
AlliedWare Plus
Command
Syntax
no network interface
Mode
Router mode
Description
This AlliedWare Plus command is equivalent to the standard command.
Examples
This example removes RIP from the VLAN2-0 interface:
awplus> enable
awplus# configure terminal
Command
Available
AlliedWare Plus