HP Hitachi Dynamic Link Manager Software - Manual (Page 607)

Message ID Message Text Explanation
Utility for Managing the HDLM
Configuration on page 7-22 .
KAPL10350-E The HDLM driver(s) is not
loaded. Refer to the Messages
section of the HDLM User's
Guide for instructions to correct
this problem.
Details
An attempt to execute the HDLM-
configuration definition utility
(dlmcfgmgr) failed because the
HDLM driver was not loaded.
Action
Carry out the following process:
a
.
Execute the following
command to load the HDLM
driver
# /opt/
DynamicLinkManager/bin/
dlminsadrv
# modprobe sddlmfdrv
b
.
Re-execute the dlmcfgmgr
utility.
For details on the dlmcfgmgr
utility, see dlmcfgmgr Utility
for Managing the HDLM
Configuration on page 7-22 .
KAPL10351-E The specified HDLM-
configuration definition utility is
invalid. Operation name =
aa...aa, Parameter = bb...bb
Details
An attempt to execute the HDLM-
configuration definition utility
(dlmcfgmgr) failed because the
specified operation name
(aa...aa:) or parameter (bb...bb)
was invalid.
aa...aa: Operation name
bb...bb: Parameter
Action
Confirm that the operation name
and parameter are correct, and
then re-execute the dlmcfgmgr
utility. For details on the
dlmcfgmgr utility, see
dlmcfgmgr
Utility for Managing the HDLM
Configuration on page 7-22 .
KAPL10352-W The HDLM device is in use.
HDLM device = aa...aa. Stop the
application using the HDLM
device, unmount the HDLM
device being mounted, and then
execute the dlmcfgmgr utility
again.
Details
An attempt to execute the HDLM-
configuration definition utility
(dlmcfgmgr) failed because the
specified HDLM device (aa...aa)
was using it.
aa...aa: HDLM device name
Action
Stop the application using the
HDLM device, unmount the HDLM
Messages
8-95
Hitachi Dynamic Link Manager User Guide for Linux ®