HP Hitachi Dynamic Link Manager Software - Manual (Page 350)

2
.
To initialize statistical information for all the paths managed by HDLM,
execute the dlnkmgr command's clear operation with the -pdst
parameter specified.
The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr clear -pdst
KAPL01049-I Would you like to execute the operation? Operation
name = clear [y/n]:y
KAPL01001-I The HDLM command completed normally. Operation name
= clear, completion time = yyyy/mm/dd hh:mm:ss
#
3
.
Check to see whether the statistical information for all the paths has been
initialized.
The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -path
Viewing and Setting Up the Operating Environment
This section explains how to display and set up the HDLM operating
environment.
Viewing the Operating Environment
To display the operating environment, execute the dlnkmgr command's view
operation with the -sys and -sfunc parameters specified.
The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 3
Elog File Size (KB) : 9900
Number Of Elog Files : 2
Trace Level : 0
Trace File Size(KB) : 1000
Number Of Trace Files : 4
Path Health Checking : on(30)
Auto Failback : on(1)
Reservation Status :
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
To display the operating environment of the audit log, execute the HDLM
command's view operation with the -sys and -audlog parameters specified.
The following example shows how to execute the command:
4-18
HDLM Operation
Hitachi Dynamic Link Manager User Guide for Linux ®