HP Hitachi Dynamic Link Manager Software - Manual (Page 295)

Setting the Audit Log Facility
The following describes how to specify the output destination for audit log
data.
If you want to specify the output destination for audit log data, first specify
the audit log facility by using the dlnkmgr set -audfac command. Next,
define the output destination of the facility in the /etc/syslog.conf file. The
table below lists the values for the audit log facility setting. The default is
user.
Table 3-76 Values Indicating Audit Log Facility
Value Corresponding facility value in the /etc/syslog.conf file
user or 1 user
local0 or 16 local0
local1 or 17 local1
local2 or 18 local2
local3 or 19 local3
local4 or 20 local4
local5 or 21 local5
local6 or 22 local6
local7 or 23 local7
This example shows how to specify the audit log facility:
# /opt/DynamicLinkManager/bin/dlnkmgr set -audfac local0
Checking the Updated Settings
This chapter describes steps involved in how to check the new settings by
using the dlnkmgr command's set operation after the new settings are
applied.
When you some these settings, you can display information about all of HDLM
function settings. The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -sfunc
HDLM Version : x.x.x-xx
Service Pack Version :
Load Balance : on(extended lio)
Support Cluster :
Elog Level : 2
Elog File Size(KB) : 1000
Number Of Elog Files : 5
Trace Level : 1
Trace File Size(KB) : 2000
Number Of Trace Files : 10
Creating an HDLM Environment
3-223
Hitachi Dynamic Link Manager User Guide for Linux ®