HP Hitachi Dynamic Link Manager Software - Manual (Page 172)

Figure 3-6 Example of the Contents of the syslogd Settings File (In Red
Hat Enterprise Linux)
When you collect audit log data, we recommend that you use any of the
extended facilities (local0 to local7) as the exclusive output destination for
the data. We also recommend that you specify info as the severity level for
the extended facility. This example shows how to specify the recommended
settings in the /etc/syslog.conf file:
local0.info /usr/local/audlog
Setting the Mount Point (in Red Hat Enterprise Linux 5 or Red Hat Enterprise
Linux 6)
In Red Hat Enterprise Linux 5 or Red Hat Enterprise Linux 6, a DVD-ROM is
not automatically mounted.
Create the /media/cdrom directory beforehand.
Checking the Partition
Confirm that the /etc/opt directory is located on the same partition as the
root directory (/).
Create the /etc/opt directory in advance when configuring the OS.
Xen Settings
If Xen is being used, make sure that domainU has been stopped. If domainU
has been set to automatically start whenever domain0 starts, temporarily
change the setting so that domainU will not start automatically.
Performing a New Installation of HDLM
This subsection describes how to perform a new installation of HDLM. The
preparations before newly installing HDLM are required. For details about the
preparations before installing HDLM, see Preparations for a New Installation
of HDLM on page 3-96 .
To perform a new installation of HDLM:
1
.
Log on to Linux as the root user.
2
.
Prepare the license key.
Use either of the following methods to store the license key file in the
specified directories:
3-100
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Linux ®