HP Hitachi Dynamic Link Manager Software User Manual
Page 244
Reading all physical volumes. This may take a while...
Found volume group "VolGroup00" using metadata type lvm2
20
.
Check the relationship between the volume group and HDLM devices.
Execute the following command to make sure that the physical volumes
that make up the volume group are not HDLM devices.
21
.
Perform an upgrade installation of HDLM.
To perform an upgrade installation of HDLM, see
Installation of HDLM on page 3-112
, perform steps 2 to 12 to create an
HDLM device. You will also need to perform step 13 if you are only
restarting the host. Note that the procedure differs depending on whether
the host is restarted after installation.
22
.
Execute the dlmcfgmgr utility with the -v parameter specified to check
the correspondence between the HDLM device and the SCSI device.
3-172
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Linux
®