HP Hitachi Dynamic Link Manager Software - Manual (Page 226)

25
.
In the boot loader configuration file, edit the settings to be used during a
boot.
¢
When GRUB is the boot loader
Change the default number so that a boot can be performed using
the configuration copied in step 21.
default=3
¢
When LILO or ELILO is used as the boot loader:
Specify label for default.
default=HDLM-HDLM_194.EL
26
.
If LILO is used as the boot loader, execute the /sbin/lilo command to
have the new settings take effect.
27
.
Edit the /etc/fstab file.
Change the mount points for the following HDLM management-target
devices from the SCSI device to the HDLM device:
¢
When ELILO is used as the boot loader:
Root directory (/), /boot/efi, /tmp, /usr, /var, swap
¢
When GRUB is used as the boot loader:
Root directory (/), /boot, /tmp, /usr, /var, swap
¢
When LILO is used as the boot loader:
Root directory (/), /tmp, /usr, /var, swap
Comment out the existing SCSI device specification by placing a hash
mark (#) at the beginning of each line, and then add the HDLM device
specification as shown below, based on the correspondence between the
SCSI device and the HDLM device as checked in step 18.
:
:
#/dev/sddlmaa2 / ext2 defaults 1 1
#/dev/sda2 / ext2 defaults 1 1
/dev/sddlmaa2 / ext2 defaults 1 1
:
:
#/dev/sddlmaa4 /tmp ext2 defaults 1 2
#/dev/sda4 /tmp ext2 defaults 1 2
/dev/sddlmaa4 /tmp ext2 defaults 1 2
:
:
28
.
Shut down the host.
Execute the following command to shut down the host:
# shutdown -h now
29
.
Change the configuration from a single-path configuration to a multi-path
configuration.
30
.
Start the host.
3-154
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Linux ®