HP Hitachi Dynamic Link Manager Software - Manual (Page 458)

Parameters
To Add a Path Dynamically
-path
Indicates that the target of the operation is a path managed by HDLM.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr add -path
KAPL01161-I This operation will change the path configuration.
Do you want to continue? [y/n]:y
KAPL01162-I A path was added. (path ID = 00010, storage =
HITACHI.HUS100.9100163, iLU = 0030)
:
KAPL01159-I Paths were added. (number of paths added = 2,
completion time = yyyy/mm/dd hh:mm:ss)
-s
Executes the command without displaying the message asking for
confirmation of command execution from the user. Specify this parameter
if you want to skip the response to the confirmation message: for
example, when you want to execute the command in a shell script or
batch file.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr add -path -s
KAPL01162-I A path was added. (path ID = 00010, storage =
HITACHI.HUS100.9100163, iLU = 0030)
:
KAPL01159-I Paths were added. (number of paths added = 2,
completion time = yyyy/mm/dd hh:mm:ss)
Note:
The path to be managed by HDLM must be recognized by the OS before
executing this command. To add paths, execute the command for adding
the device shown in Table 4-3 Adding or Deleting a SCSI Device on page
4-38 .
To Display the Format of the add Operation
-help
Use this parameter to display the add operation format.
Example
# /opt/DynamicLinkManager/bin/dlnkmgr add -help
add:
Format
dlnkmgr add -path [-s]
KAPL01001-I The HDLM command completed normally. Operation name
= add, completion time = yyyy/mm/dd hh:mm:ss
#
6-64
Command Reference
Hitachi Dynamic Link Manager User Guide for Linux ®