HP Hitachi Dynamic Link Manager Software - Manual (Page 354)

Path Health Checking : on(30)
Auto Failback : on(1)
Reservation Status :
Intermittent Error Monitor : off
Dynamic I/O Path Control : off(10)
HDLM Manager Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
HDLM Alert Driver Ver WakeupTime ElogMem Size
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss 1000
HDLM Driver Ver WakeupTime
Alive x.x.x-xx yyyy/mm/dd hh:mm:ss
LicenseType Expiration
Permanent -
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
Among the displayed items, HDLM Manager, HDLM Alert Driver, and HDLM
Driver indicate the HDLM component information.
Also, you can view information for each HDLM component. Execute the
dlnkmgr command's view operation with the -sys and subsequent parameter
specified. The following is an example of executing the command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -msrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -adrv
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -pdrv
Starting and Stopping the HDLM Manager
If an error occurs in the system, such as in an HDLM program, you may need
to manually stop or start HDLM to recover from the error.
Starting the HDLM Manager
To start the HDLM manager, log in to Linux as a user with root permissions
and then execute the following command.
# /etc/init.d/DLMManager start
Starting DLMManager: [ OK ]
Lower case characters can be used for the command name (dlmmanager).
# /etc/init.d/dlmmanager start
Starting DLMManager: [ OK ]
The startup script that was set up during HDLM installation runs, and starts
the HDLM manager.
Note
¢
When you start the HDLM manager immediately after stopping it,
confirm that the HDLM manager has stopped (Dead is displayed when
4-22
HDLM Operation
Hitachi Dynamic Link Manager User Guide for Linux ®