HP Hitachi Dynamic Link Manager Software User Manual
Page 228
root = /dev/disk/by-id/scsi-35001862001472c70-part12
multipath=off is set in the underlined section.
¢
When GRUB is used as the boot loader with Xen kernels:
For details on Xen kernels, see
Table 3-61 Xen Hypervisor Operating
Environments Supported by HDLM on page 3-88
:
:
title XEN
root (hd0,0)
kernel /xen-pae.gz
module /vmlinuz-2.6.16.60-0.54.5-xenpae \
root=/dev/disk/by-id/scsi-SFUJITSU_MAS3735NC_A050P360007N-
part6 vga=0x317 \
resume=/dev/disk/by-id/scsi-
SFUJITSU_MAS3735NC_A050P3600077-part2 \
splash=silent showopts multipath=off
module /initrd-2.6.16.60-0.54.5-xenpae
multipath=off is set in the underlined section.
¢
When GRUB is used as the boot loader with non-Xen kernels:
For details on kernels supported by HDLM, see
.
:
:
title SUSE LINUX Enterprise Server 10 SP3
root (hd0,0)
kernel /vmlinuz-2.6.16.60-0.54.5-smp root=/dev/VG/root
vga=0x31a \
resume=/dev/VG/swap splash=silent showopts multipath=off
initrd /initrd-2.6.16.60-0.54.5-smp
multipath=off is set in the underlined section.
3
.
Check the definition in the /etc/fstab file.
The following shows an example of the content of the /etc/fstab file.
Figure 3-8 Example Content of /etc/fstab file When using LVM2
LABEL is set in the shaded portion.
This example assumes that IA32 uses GRUB as the boot loader. When you
use IPF that uses ELILO as the boot loader, the mount point is displayed
3-156
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide for Linux
®