HP Hitachi Dynamic Link Manager Software - Manual (Page 426)

To display corresponding information about an HDLM device, SCSI device, and
LDEV
/opt/DynamicLinkManager/bin/dlnkmgr view -drv [-t]
To Display the Format of the view Operation
/opt/DynamicLinkManager/bin/dlnkmgr view -help
Parameters (To display program information)
This section describes the parameters for the view operation, in the following
order:
To display program information on page 6-32
To display path information on page 6-39
To display LU information on page 6-51
To display corresponding information about an HDLM device, SCSI device,
and LDEV on page 6-61
To display the format of the view operation on page 6-62
To display program information
-sys [-sfunc|-msrv|-adrv|-pdrv|-lic|-audlog|-lbpathusetimes|-
expathusetimes]
Displays the HDLM program information.
Use one of the sub-parameters (following -sys) to specify the program
information that you want to display. If you do not specify a sub-
parameter, the command displays all of the program information except
the information about the audit log data collection settings, the number of
times the same path can be used for load balancing, and the number of
times the same path can be used for extended load balancing.
Table 6-10 Displayed Program Information on page 6-32 shows the
parameters you can specify and the displayed information.
-t
Does not display the title for each information item.
Table 6-10 Displayed Program Information
Parameter
and program
information to
be displayed
Item Description
-sfunc
Information
about the HDLM
function
settings
HDLM Version HDLM version number
Service Pack
Version HDLM SP version number. This item is blank if no
SP is present.
Load Balance Settings for load balancing
6-32
Command Reference
Hitachi Dynamic Link Manager User Guide for Linux ®