HP Hitachi Dynamic Link Manager Software - Manual (Page 287)

#
To check the current audit log settings, execute the following command:
# /opt/DynamicLinkManager/bin/dlnkmgr view -sys -audlog
Audit Log : off
Audit Log Category : -
Audit Log Facility : -
KAPL01001-I The HDLM command completed normally. Operation name =
view, completion time = yyyy/mm/dd hh:mm:ss
#
Setting Up the HDLM Functions
The table below summarizes the functions that can be set in HDLM. For
details about each function, see Setting Up Load Balancing on page 3-216
and subsequent sections.
Each function has a default value and a recommended value. If no function is
set by the HDLM command's set operation, the default value is applied for
each function. The recommended values are used as the guideline values
when functions are configured.
Table 3-71 The Recommended and Default Values of Each Function
Function Default value Recommended value
Load-balancing on
The Extended Least I/Os
algorithm is used.
on
The recommended algorithm
depends on the operating
environment.
Path health checking on
30-minute check interval on
The recommended checking
interval depends on the
operating environment.
Automatic failback on
1-minute check interval The recommended checking
interval depends on the
operating environment.
Intermittent Error
Monitor
off off
Dynamic I/O path
control
#
off
10-minute check interval off
The recommended checking
interval depends on the
operating environment.
Logging level 3: Collects all the error
information for the
"Information" level or higher
3: Collects all the error
information for the
"Information" level or higher
Trace level 0: Do not output trace files 0: Do not output trace files
File size for the Error
log
9900 (KB) 9900 (KB)
Creating an HDLM Environment
3-215
Hitachi Dynamic Link Manager User Guide for Linux ®