HP MPX200 Multifunction Router - Manual (Page 91)

Specifies the LUN T10 designator. -lun_tten=
3
Specifies the VP group index number for the new data management LUN. -vpgindex=
1 Do not combine the keywords -array_with_lun_serial, -array_with_lun_wwuln, -array_with_lun_tten,
-array_with_lun_eui , and -array_with_lun_naa. To specify any LUN, use the -array_with_lun_any_wwuln
keyword.
2
You can use either the -fc_target or the -is_target keyword, but not both.
3
Do not combine the keywords -lun_serial, -lun_wwuln, -lun_tten, -lun_eui and -lun_naa. To specify any
LUN, use the -lun_any_wwuln keyword.
Example
c:\> rcli add dml -lun_number=2 -vpgindex=1
-fc_target=5001-4380-025D-A83A /ip=10.0.0.12
[10.0.0.12]
add migration
The add migration command adds a new data migration job.
Syntax
add migration -dm_type=offline | verify_after_offline | online |
remote_online | compare | scrub
You must identify the source array using one of the following keywords:
•
-array_with_fc_target
•
-array_with_is_target
•
-array_array_wwpn
•
-array_with_name
•
-array_with_lun_wwuln
•
-array_with_lun_eui
•
-array_with_lun_naa
•
-array_with_lun_serial
•
-array_with_lun_tten
•
-array_with_lun_any_wwuln
You must identify the destination array using one of the following keywords:
•
-dmdest_array_with_fc_target
•
-dmdest_array_with_is_target
•
-dmdest_array_array_wwpn
•
-dmdest_array_with_name
•
-dmdest_array_with_lun_wwuln
•
-dmdest_array_with_lun_eui
•
-dmdest_array_with_lun_naa
•
-dmdest_array_with_lun_serial
•
-dmdest_array_with_lun_tten
•
-dmdest_array_with_lun_any_wwuln
add migration 91