HP MPX200 Multifunction Router - Manual (Page 50)

•
on
•
off
•
true
•
false
The default is the current setting on the router.
Specifies the maximum quantity of concurrent I/Os that the router issues to the specified
array. Values are: -max_concurrent_io
•
32
•
64
•
128
•
256
The default is the current setting on the router.
NOTE: This keyword is supported with keyword router firmware 3.3.1.0 or later.
Specifies a symbolic name to apply to this storage array. -name=
The default is the current setting on the router.
1
Do not combine the keywords -array_with_lun_serial, -array_with_lun_wwuln, -array_with_lun_tten,
-array_with_lun_eui , and -array_with_lun_naa. To specify any LUN, use the -array_with_lun_any_wwuln
keyword.
Example
c:\> rcli set array -array_wwpn=0000-0100-0100-0000 -name="HP HSV340-0"
/ip=10.0.0.12
Storage Array 0000-0100-0100-0000 successfully configured
set chassis
The set chassis command sets the chassis name and lists the current chassis configuration.
Use the -name keyword to specify a text string no longer than 64 characters as the chassis name.
To specify a chassis name that contains spaces, enter the name within quotation marks.
NOTE: Single-controller routers (MPX100) do not support this command.
Syntax
set chassis -name=name
Example
c:\> rcli set chassis -name="My Multifunction Router" /ip=10.0.0.12
[10.0.0.12]
Product Name = MPX200
Serial Number = 0823E00012
Symbolic Name = My Multifunction Router
Operation Mode = ISCSI_CONNECTIVITY
Use IQN = NO_NAME_OR_SERIAL
SW Version = 3.2.0.0rc5e
HW Version = 00000-01
FC port count = 2
iSCSI port count = 4
Target Presentation Mode = AUTO_TARGET_PRESENTATION
LUN Mapping = Enabled
Controller LUN Automap = Disabled
Target Access Control = Enabled
Telnet = Enabled
50 Command reference