HP MPX200 Multifunction Router - Manual (Page 80)

Syntax
show snmp
Example
c:\> rcli show snmp /ip=10.0.0.12
[10.0.0.12]
-read_community=public -trap_community=private -location="Server Room"
[email protected] -auth_enable=no -trap_index=0 -trap_ipaddr=10.0.0.10
-trap_port=1026 -trap_version=0
show status
The show status command displays status information for the router.
Syntax
show status
Example
c:\> rcli show status /ip=10.0.0.12
[10.0.0.12]
Sequence Number = 4
Alarm Status = Off
Hardware Status = 0
Temperature at Board Front = 0x35, 53 C.
Temperature at Board Rear = 0x25, 37 C.
Temperature of CPU #1 = 0x1ae, 43 C.
Temperature of CPU #2 = 0x1b8, 44 C.
Bridge Mask = 0x40008
Bridge Mask Ext = 0x0, 0x0, 0x4, 0x0
show system
The show system command displays system information, including serial number and firmware
version.
Syntax
show system
Example
c:\> rcli show system /ip=10.0.0.12
[10.0.0.12]
Product Name = iSR
6200
Serial Number = 0823E00012
Symbolic Name = Blade-1
Operation Mode = ISCSI_CONNECTIVITY
Use IQN = NO_NAME_OR_SERIAL
SW Version = 3.2.0.0rc5e
HW Version = 00000-01
FC port count = 2
iSCSI port count = 4
Target Presentation Mode = AUTO_TARGET_PRESENTATION
LUN Mapping = Enabled
Controller LUN Automap = Disabled
Target Access Control = Enabled
80 Command reference