Set system, Example, Syntax – HP MPX200 Multifunction Router User Manual
Page 60: Keywords
The default is the current setting on the router.
Specifies the SNMP trap version.
-trap_version=
Values are 1, 2, or 3.
The default is the current setting on the router.
Example
c:\> rcli set snmp -location="Server Room" [email protected]
-auth_enable=n -trap_index=0 -trap_enable=yes -trap_ipaddr=10.0.0.10
-trap_port=1026 /ip=10.0.0.12
SNMP -trap_index=0 successfully configured
set system
The set system command sets global control and display items for the router, including symbolic
name, enable or disable controller LUN automatic mapping, LUN mapping, and target presentation
mode.
IMPORTANT:
You must reboot the router after issuing this command.
Syntax
set system
Keywords
Specifies whether automatic LUN mapping is enabled or disabled for the controller.
Values are:
-controller_lun_automap=
•
yes
•
no
•
on
•
off
•
true
•
false
The default is the current setting on the router.
Specifies whether FTP is enabled or disabled for the router. Values are:
-ftp=
•
yes
•
no
•
on
•
off
•
true
•
false
The default is the current setting on the router.
NOTE:
This keyword requires router firmware Version 3.2.0.0 or later.
Specifies whether LUN mapping is enabled or disabled for the router. Values are:
-lun_mapping=
•
yes
•
no
•
on
•
off
60
Command reference