HP MPX200 Multifunction Router - Manual (Page 67)

NOTE: The router must be capable and licensed for FCIP.
Syntax
show fcip_route
Keywords
Specifies the Fibre Channel port for which to display FCIP route information. -fc_port=
If this keyword is not used, the command displays information for all FCIP routes.
Example
c:\> rcli show fcip_route /ip=10.0.0.12
[10.0.0.12]
FC port number 1
FCIP interface: Enabled
GE port number 1
GE Remote IP Address 10.0.2.10
GE Local Address: 10.0.0.10
GE Subnet Mask: 0.0.0.0
GE Gateway Address: 10.0.0.1
MTU Size 1500
TCP Window Max Size TCPWINDOWSIZE_16777216
Port Speed GE_PORT_SPEED_AUTO
Bandwidth 20
VLAN Disabled
FCIP S/W Compression Disabled
Link Status LINK_DOWN
GE Link Status LINK_DOWN
show fcip_statistics
The show fcip_statistics command samples FCIP statistics data over a specified interval
and displays the result scaled to per-second units.
Syntax
show fcip_statistics
Keywords
Identifies a folder into which an individual file containing csv files is created for
each port. -csv_folder=
Files are created, or appended to if they already exist.
Specifies the time, in seconds, for FCIP port statistics data collection. Regardless of
the length of this interval, results are displayed in per-second units. -seconds=
The default collection interval is two seconds.
Example
c:\> rcli show fcip_statistics /ip=10.0.0.12
FCIP Route 1
FC Xmit Frames 164
FC Rcvd Frames 0
IP Xmit Packets 9758
IP Xmit Byte Count 0
IP Xmit Fragments 613
show fcip_statistics 67