Show target, Show time, Show vlan – HP MPX200 Multifunction Router User Manual
Page 81: Show target show time show vlan, Syntax, Keywords, Example
Telnet = Enabled
SSH = Enabled
show target
The show target command displays detailed information for a single target.
If you do not specify a target, detailed information is displayed for all targets.
TIP:
To view all targets known to the router, use the list target command.
Syntax
show target
Keywords
Specifies the name of the Fibre Channel target for which you want to view detailed
information.
-fc_target=
1
Specifies the name of the iSCSI target for which you want to view detailed
information.
-is_target=
1
1
You can specify either -fc_target or -is_target, but not both.
Example
c:\> rcli show target -fc_target=5001-4380-025D-A83E
Fibre Channel Target
WWNN: 5001-4380-025D-A830
WWPN: 5001-4380-025D-A83E
Port ID = 0A-07-00-00
MP Virtual target = Yes
Portal = 0
Target State = ONLINE
Target Device Mode = SMART_WRITE_DISABLED
Target Device Path = Port 1, Port 2
show time
The show time command displays the date and time currently set on the router.
Syntax
show time
Example
c:\> rcli show time /ip=10.0.0.12
[10.0.0.12]
-gmt="04/08/2010 17:28:29"
-local="04/08/2010 10:28:29"
show vlan
The show vlan command displays VLAN information for the specified port.
If you do not specify a port, VLAN information is displayed for all ports.
TIP:
To view VLAN information for all ports, use the list vlan command.
show target
81