HP MPX200 Multifunction Router - Manual (Page 59)

Example
c:\> rcli set presented -chap_enable=yes -chap_secret="my password"
-is_target=iqn.1986-03.com.qlogic:fcgw.mpx200.0823e00014.b2.02.50014987625da3
24 /ip=10.0.0.12
CHAP secret successfully enabled for iSCSI Presented Target
iqn.1986-03.com.qlogic:fcgw.mpx200.0823e00014.b2.02.50014987625da324
set snmp
The set snmp command sets the SNMP parameters.
Syntax
set snmp
Keywords
Specifies if authentication is enabled or disabled for SNMP. Values are: -auth_enable=
•
yes
•
no
• on
•
off
• true
•
false
The default is the current setting on the router.
Specifies the name of the SNMP system contact. -contact=
The default is the current setting on the router.
Specifies the SNMP system location. The default is the current setting on the router. -location=
Specifies the SNMP read community. -read_community=
The default is the current setting on the router.
Specifies the SNMP trap community. -trap_community=
The default is the current setting on the router.
Specifies if SNMP traps are enabled or disabled. Values are: -trap_enable=
•
yes
• no
•
on
• off
•
true
•
false
The default is the current setting on the router.
Specifies an integer in the range of 0 to 7 for the SNMP trap array index. -trap_index=
Default value is 0.
Specifies the IPv4 or IPv6 address for the SNMP trap. -trap_ipaddr=
The default is the current setting on the router.
Specifies the maximum number of SNMP trap ports. -trap_port=
Values are in the range of 1 to 65535.
set snmp 59